košík je prázdný
košík je prázdný

TB 20 CANopen® Slave

PDFTisk
The CANopen® bus coupler is designed to connect a CAN bus to TB20 peripheral modules.

Kod produktu: 600-160-1AA11

Popis

It supports the CANopen® protocol as defined in DS 301 and uses the DSP-401 profile for digital and analog I/O modules.
A functioning TB20 configuration will always require a bus coupler and at least one peripheral module, but can accommodate up to 64 modules of any kind connected in series with the bus coupler. The bus coupler supports hot-plug for replacing modules during operation.
In addition, this coupler makes it possible to use SDOs to freely access all I/O values, parameters, and diagnostics, and can manage up to 192 bytes of I/O data with the PDO protocol.

Note:

The 24 V power supply connector, the final bus cover, and the base module are included as standard.
TB20 ToolBox makes it easy to methodically design TB20 systems. Integrated terminal mapping, system width calculations, and current-carrying capacity monitoring all make it possible to quickly design systems without making any mistakes. 

Characteristics

• CANopen® protocol as defined in DSP301 and DS401
• Baud rates of 50 kbps to 1 Mbps
• 24 TPDOs / 24 RPDOs
• One SDO server
• Heartbeat producer
• Two heartbeat consumers
• Node guarding
• SYNC object
• Storable parameter configuration
• Up to 64 peripheral modules
• Modules can be replaced during operation (hot-plug)
• 24 VDC power supply
• Integrated power supply unit for powering peripheral modules (2.5 A)
• Supplies the system’s I/O voltage (24 VDC)
• DIP switch for setting the node ID and baud rate; can be covered
• 5 LEDs, two of them bi-color
• USB device port for online diagnostics, configuring parameters, setup, and firmware updates with "TB20 ToolBox"
• TB20 ToolBox simulation for setting up the I/O system without a higher-level controller in order to test the system`s
  operation (I/O check)

Kontakt

Česká republika
INTERSOFT - Automation s.r.o.
IČ: 49194437
Nepomucká 1355/261, 326 00 Plzeň-Černice
GPS: 49.6972006N, 13.4277131E

Anton Mózer - Elektronika, s.r.o.
Zvolenská 99, Modrý Kameň, 992 01

 

mobil: +420 602 647 033
telefon: +420 377 680 947
fax: +420 377 680 940
Po - Pá:  8:00 - 18:00
So - Ne: po domluvě
Kontaktní osoba: Michal Hlavatý
email:  
michal.hlavaty@intersoft-automation.cz
helmholz@intersoft-automation.cz
telefon:   00421 (0)47 4870 294
fax:   00421 (0)47 4870 294
e-mail:   ame@helmholz.sk
Po - Pá:   8:00 - 17:00
So - Ne:   po domluvě

Newsletter

Přihlaste se k odběru novinek.
captcha